 "loco pilots, railway staff, train tracks, railways dept")
The CRS said in case of multiple signal failures, there were three options left with the rail administration but they followed none of them in total.
The Commissioner of Railway safety has said the Kanchanjunga express accident involving a goods train was “waiting to happen” due to lapses at multiple levels in managing train operations in automatic signal zones, and “inadequate counselling” of loco pilots and station masters.
In its probe report into the June 17 accident that left 10 persons dead, including the loco pilot of the goods train, the Commissioner of Railway Safety (CRS) also recommended implementation of the Automatic Train-protection system (KAVACH) on top priority.
The CRS said wrong paper authority or T/A 912 to cross defective signals was issued to the loco pilot of the goods train involved by authorities concerned. Further, the paper authority didn’t mention the speed that the goods train driver was supposed to follow while crossing the defective signal.
Considering various lapses on part of the rail administration, the CRS said, “Due to improper authority and that too without adequate information, such an incident was an “accident-in-waiting”.
The CRS, in its probe, found that besides the Kanchanjunga Express and the goods train, five other trains entered the section from when the signals turned defective until the accident happened on that day.
“In spite of issuing the same authority, different speed pattern was followed by loco pilots,” it said.
The CRS noted that only the Kanchanjunga Express followed the norm of moving at a maximum speed of 15 kmph and stopping for one minute at each defective signal while the rest of the six trains, including the goods train involved in the accident, didn’t follow this norm.
PTI had first reported that the T/A 912 didn’t mention speed restriction which the CRS has also flagged in its report as a major reason for the accident.
It said the large number of signalling failures in automatic signalling territory is a cause of concern and should be taken up with those concerned to improve the reliability of the system.
“The occurrence of as many as 208 cases of Signal Passing at Danger (red signal overshooting) from 1.4.2019 to 31.03.2024, out of which 12 cases resulted in collision, highlights the limitations of preventive measures taken by zonal railways (counselling of loco pilot/assistant loco pilot, safety drives, etc.),” the CRS said.
“This underscores the need for implementation of the Automatic Train-protection system (KAVACH) on top priority. Use of non-signalling-based systems such as Artificial intelligence-based detection of the RED aspect of the signal and providing an early warning to the loco pilot/GPS-based anti-collision systems shall be explored for provision in locomotive cabs across Indian Railways in non-ATP (automatic train protection) territory,” it said.
The CRS said in case of multiple signal failures, there were three options left with the rail administration but they followed none of them in total.
The first option was to let the drivers follow the general rule under which the loco pilot has been instructed to stop the train for one minute at the defective signal and then proceed with great caution till the next stop signal.
The second option was that the drivers should have been issued a T/A 912 form with a caution order (mentioning the speed that the driver should have maintained). In the Kanchanjuga tragedy, the T/A 912 issued to the goods train crew didn’t mention the speed aspect.
The third option was that authorities should have treated that as a “major signal failure” and followed Automatic Block System. Under the provision, only one train is allowed to enter between two stations and till the time the proceeding train crosses the next station, no train is permitted to enter from the first station.
According to the CRS, as per the Railway Board’s norm, the control office at the divisional level shall be manned by one Senior Section Engineer, one Junior Engineer and one helper round-the-clock in an 8-hour shift.
“There was also a shortage of walkie-talkies in the Northeast Frontier Railway (NFR) Zone under whose jurisdiction the accident took place,” it said.
“Since the automatic signalling was introduced in January 2023, it was necessary to ensure that all rules applicable to the automatic signalling are implemented properly at the field level. The widespread misinterpretation of rules indicates there was no system of checks and balances at the headquarter level,” it added.
(Only the headline and picture of this report may have been reworked by the Business Standard staff; the rest of the content is auto-generated from a syndicated feed.)
First Published: Jul 16 2024 | 1:14 PM IST
